.png)
Delta Sama Jaya Sdn Bhd
23G & 23M, DSSB Building,
Jalan Perdana 6/8,
Pandan Perdana,
55300 Kuala Lumpur,
Malaysia.
+603 9286 6328
+603 9281 3778
+603 9282 4007
+603 9281 3778
+603 9282 4007
+603-9287 0705
Ceramic Mold
| Previous | 5 / 7 | Next |
One Time Ceramic Mold
Ceramic mold can be broke down or buried in place where the weld is completed. It is suitable for simple welding such as 2-way cable, 3-way cable, 1-way cable to rod, 2-way cable to rod, etc.
The ceramic mold is set in one-time kit consist of mold, welding powder and disk.
Setup the ceramic mold in a proper flat and stable ground. After the conductors are in their position, please put the disc into mold.
Gently pour the weld powder into the mold.
Close the Ceramic Mold with the lid cover and pour gently traces of the ''Starting Powder'' on the cover lid.
Use the flint gun to ignite the Starting Powder.
The ignition takes place.
The exothermic process start immediately.
After the exothermic welding is completed, Leave the mold to cool down.
WARNING
Gently break the mold.
The weld form is complete.
DSSB products shall be installed and used only as indicated in our product instruction sheets and training materials. Instruction sheets are available upon request. Improper installation, misuse, misapplication or other failure to completely follow instructions and warnings may cause product malfunction, property damage, serious bodily injury and death.
